BCM Community

Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: mccarlk on November 11, 2008, 04:57:20 PM

Title: QUESTION FOR TOMC
Post by: mccarlk on November 11, 2008, 04:57:20 PM

hi tom , where did you run your oil drain from the turbo, also do have any pics of the way you mounted your turbo, thanks

Title: Re: QUESTION FOR TOMC
Post by: TomC on November 12, 2008, 08:42:47 AM

Don Fairchild used an unused block plug in the crankcase above the oil line for the oil return.  Hopefully this picture came through.  Good Luck, TomC

Title: Re: QUESTION FOR TOMC
Post by: TomC on November 12, 2008, 08:52:57 AM

I apologize for the quality, don't quite know what happened-the picture was taken with a 10.2mp camera.  Good Luck, TomC

Title: Re: QUESTION FOR TOMC
Post by: Songman on November 12, 2008, 12:01:33 PM

I'll see if I can get a better picture if needed, but it is like Tom said. Don just always picks an unused port that is low on the side of the block and pipes the turbo oil back into the engine there. It goes right back into the oil pan and ready to be filtered and used again.