Author Topic: Any one have anything good or bad to say about this impact gun. SK-92141  (Read 1831 times)

Offline zubzub

  • Hero Member
  • *****
  • Posts: 1212
  • '53 4104. Roadworthy but rough around the edges.
    • pics of my bus etc....
It's a 3/4" impact with 1200 ft/lbs of torque. 
http://www.skhandtool.com/Default.aspx?fusemode=10&pid=92141
Guy is selling it cheap ($150) a little worn but will do for me unless it has some kind of weakness I haven't been able to find online.  Basically I have a 1/2" with about 450 ft/lbs but need something a lot stronger for soem of the hard to reach palces and my 1" impact is a monster and basically a mistake at this point I will sell it once I get a decent 3/4".  So any info helpful.

Offline Just Dallas

  • Bus Conversion Stuff on a Budget
  • Hero Member
  • *****
  • Posts: 846
    • BCS
Re: Any one have anything good or bad to say about this impact gun. SK-92141
« Reply #1 on: February 06, 2010, 04:45:17 PM »
Removed
« Last Edit: July 15, 2010, 12:54:57 PM by Now Just Dallas »
I'm just an old chunk of coal... but I'm gonna be a diamond someday.

Offline busnut104

  • Full Member
  • ***
  • Posts: 217
Re: Any one have anything good or bad to say about this impact gun. SK-92141
« Reply #2 on: February 06, 2010, 05:30:15 PM »
I bought a I/R on e-bay I believe the # is 231 but not sure around 1200lb tork, around 100.00 bucks nice shape,  do not be in a hurry and watch e-bay.

Offline zubzub

  • Hero Member
  • *****
  • Posts: 1212
  • '53 4104. Roadworthy but rough around the edges.
    • pics of my bus etc....
Re: Any one have anything good or bad to say about this impact gun. SK-92141
« Reply #3 on: February 07, 2010, 07:09:17 PM »
Looking for the big 1200 ft/lbs so 3/4"it is. No one have this gun? I figure it's probably good, I can handle the weight, would be surprised if my 1/2" weighed less.

Offline wrench

  • Full Member
  • ***
  • Posts: 166
Re: Any one have anything good or bad to say about this impact gun. SK-92141
« Reply #4 on: February 08, 2010, 04:53:47 AM »
It's a 3/4" impact with 1200 ft/lbs of torque. 
http://www.skhandtool.com/Default.aspx?fusemode=10&pid=92141
Guy is selling it cheap ($150) a little worn but will do for me unless it has some kind of weakness I haven't been able to find online.  Basically I have a 1/2" with about 450 ft/lbs but need something a lot stronger for soem of the hard to reach palces and my 1" impact is a monster and basically a mistake at this point I will sell it once I get a decent 3/4".  So any info helpful.

 I would go for it, if anything not up to par, there is nothing complicated in there(2 bearing, a drum, 4 fiber vanes, 1 hammer,1 anvil). & SK you can have parts anytime.
            wrench