Author Topic: Slobber tube catch container  (Read 2542 times)

Offline eagle10

  • Full Member
  • ***
  • Posts: 107
Slobber tube catch container
« on: August 05, 2006, 05:43:17 PM »
I have been thinking about putting a oil catcher on my Eagle 10. I thought I might use a 4 inch PVC pipe with a screw out drain in the end and drill two holes in it for the rubber hoses.  What  are some other ideas that you have used? Thanks.





y

Offline Happycampersrus

  • Full Member
  • ***
  • Posts: 120
Re: Slobber tube catch container
« Reply #1 on: August 05, 2006, 06:06:43 PM »
That is the way I made mine. 8" long with caps, 2 holes for the drain hoses. Also you need to have a vent on the top of the container. My airbox would pressurize and blow a hose off. :o I used a vent from an old DANA rearend housing. 8)


Dale

Offline JackConrad

  • Orange Blossom Special II
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4448
  • 73' MC-8 8V71/HT740 Southwest Florida
Re: Slobber tube catch container
« Reply #2 on: August 06, 2006, 05:46:32 AM »
I used 3" PVC about 15" long. I drilled and tapped two  1/4"  holes in top and installed barbed fittings to attach the rubber hoes. I drilled and tapped a larger hole in the top (I think it was 1/2 or 3/4") and installed a vent off of a hydrasulic tank. One 1/4" hole drilled and tappped in the bottom of one of the end caps for a drain petcock an it was done. I mounted it to the frame under the engine of our MC-8 with two large hose clamps.  YMMV Jack
Growing Older Is Mandatory, Growing Up Is Optional
Arcadia, Florida, When we are home
http://s682.photobucket.com/albums/vv186/OBS-JC/