June 24, 2018, 09:00:15 AM

Author Topic: Vibrations  (Read 4635 times)

Offline bryanhes

  • Hero Member
  • *****
  • Posts: 512
  • Eagle Model 10 "For Now"
Re: Vibrations
« Reply #15 on: April 09, 2010, 08:14:18 PM »
He is almost a rear end expert too! LOL  ;D

Offline Chopper Scott

  • Hero Member
  • *****
  • Posts: 1303
  • MCI 7
Re: Vibrations
« Reply #16 on: April 09, 2010, 08:15:05 PM »
Get the ones that aren't rusty!
Seven Heaven.... I pray a lot every time I head down the road!!
Bad decisions make good stories.

Offline luvrbus

  • Hero Member
  • *****
  • Posts: 19432
Re: Vibrations
« Reply #17 on: April 09, 2010, 08:26:41 PM »
funny Richard but the 92 parts are from a MCI I cannot believe MCI would stick a 8v92TA in a 102 wide bus and set the engine at 355 hp this engine has 7g75 injectors from the factory my thinking it is for cooling but it has the large radiators.
It did last a long time without any major work 626,000 miles only a turbo and blower seals and tune ups every 100,000 miles the gear driven alternator broke a gear and destroyed the engine 



good luck
« Last Edit: April 09, 2010, 08:33:11 PM by luvrbus »
Life is short drink the good wine first

Offline rdbishop

  • Sr. Member
  • ****
  • Posts: 418
  • '68 MCI-7 892T, 740 Richard & Missy - Texas
Re: Vibrations
« Reply #18 on: April 09, 2010, 08:28:16 PM »
Bryan, Did I tell you that I'm going to have to pull my rear end and adjust it. Seems like when you put a truck rear end in the bus and flip it over, you put the thrust on the other side. after a little while it starts to whine. It doesn't look like I'm going to run out of stuff to do. Do you have your bedroom AC in for your trip. Come on down an I'll help you install it. I'm not to busy right now.

Chopper-- I thought they were all rusty...

Richard

Offline Chopper Scott

  • Hero Member
  • *****
  • Posts: 1303
  • MCI 7
Re: Vibrations
« Reply #19 on: April 09, 2010, 08:33:41 PM »
I forgot about my beams!
Seven Heaven.... I pray a lot every time I head down the road!!
Bad decisions make good stories.

Offline rdbishop

  • Sr. Member
  • ****
  • Posts: 418
  • '68 MCI-7 892T, 740 Richard & Missy - Texas
Re: Vibrations
« Reply #20 on: April 09, 2010, 08:34:08 PM »
Clifford, Are you parting that engine out?

Offline bryanhes

  • Hero Member
  • *****
  • Posts: 512
  • Eagle Model 10 "For Now"
Re: Vibrations
« Reply #21 on: April 09, 2010, 09:03:22 PM »
Richard,

Yup, you told me yesterday. Is that CRS kicking in again, LOL. I am hoping I do not need AC yet. I am going to run up to Jefferson the first of the week to pick up a slider to change at least one of them so we have some air flow  :o that toll window does not do much and it should be nice enough in the next couple weeks to just open a window.

Just watching a re-run of the Incredible Hulk. There was a Buffalo in the parking lot of LAX  :o
Bryan

Offline johns4104s

  • Hero Member
  • *****
  • Posts: 865
Re: Vibrations
« Reply #22 on: April 11, 2010, 02:53:49 PM »
Could it be the harmonic Balancer? Just a comment from the cheap seats,

John