Author Topic: Securing furniture and appliances to the floor ?  (Read 7629 times)

cody

  • Guest
Re: Securing furniture and appliances to the floor ?
« Reply #15 on: October 23, 2010, 12:24:54 PM »
With iggles we secure the stuff to the towed.  ;D

Offline Rick 74 MC-8

  • Sr. Member
  • ****
  • Posts: 262
Re: Securing furniture and appliances to the floor ?
« Reply #16 on: October 23, 2010, 12:38:51 PM »
With a bungee cords  when everything stops it gets snapped Back into place  :o ;D
About 20 Miles West Of Chicago

Offline happycamperbrat

  • Hero Member
  • *****
  • Posts: 1813
Re: Securing furniture and appliances to the floor ?
« Reply #17 on: October 23, 2010, 12:49:16 PM »
With all the stainless steel in the RTS I guess you could secure stuff with spit  ;D ;D ;D
The Little GTO is a 102" wide and 40' long 1983 GMC RTS II and my name is Teresa in case I forgot to sign my post

Offline Dave5Cs

  • Hero Member
  • *****
  • Posts: 3351
  • 1979 MCI MC5Cs 6V-71 644MT Allison, Roseville, CA
Re: Securing furniture and appliances to the floor ?
« Reply #18 on: October 24, 2010, 11:14:03 AM »
We put most of ours in Cabinets also. Seats are bolted through floor PITA but safe w/ seat belts that came bolted to steel seat frames.

If freestanding refrigerator you might put L brackets next to sides with plates on inside at front bottom with wing nuts and bolts going through both and a steel strap at back or top side hooked to bus side as not to tip but can be taken loose to clean behind etc.

Couches can be bolted own through floor or use big flush wing nuts. Lots of big washers. At least Grade 8 bolts. FWIW

Dave
"PATHFINDER" (PFBus)
 1998 Jeep TJ (PFTOED)