Author Topic: 4104 Leveling Block Locations  (Read 3766 times)

Offline Ed Hackenbruch

  • Hero Member
  • *****
  • Posts: 2725
Re: 4104 Leveling Block Locations
« Reply #15 on: April 20, 2014, 04:39:54 PM »
When i was putting in new air bags i had the bus raised and blocked and also used a piece of 4x4 between the bump stop and frame. During the night the wood split in two and one piece flew out and the other flipped sideways in place  and dropped the body a couple of inches. After that i took a piece of pipe and put a piece of metal on the top for the frame bumper to rest on, and put a piece about 1/2 to 3/4 inches up inside of the bottom of the pipe so it can sit on the bumper base and not slide off when the stop comes down on it.
Used to own a 1968 MCI 5A with 8V71 and Allison MT644 transmission.

Offline gus

  • Hero Member
  • *****
  • Posts: 3632
Re: 4104 Leveling Block Locations
« Reply #16 on: April 20, 2014, 07:03:53 PM »
If you cross the grain with multiple plys this won't happen, gluing is even better.

Also, solid oak blocks won't split usually. I made some from building post (that are still strong after 9 years) 4x4 by cutting them down a bit, 4" is too thick.
PD4107-152
PD4104-1274
Ash Flat, AR

Offline Ed Hackenbruch

  • Hero Member
  • *****
  • Posts: 2725
Re: 4104 Leveling Block Locations
« Reply #17 on: April 21, 2014, 03:21:41 AM »
Gus, not sure what my 4x4 was, probably fir since we were in Yuma at the time.
Used to own a 1968 MCI 5A with 8V71 and Allison MT644 transmission.

Offline gus

  • Hero Member
  • *****
  • Posts: 3632
Re: 4104 Leveling Block Locations
« Reply #18 on: April 22, 2014, 07:56:12 PM »
Oak will probably split under the right circumstances, but mine never did. It is tough as iron and was really hard on my saw blade! It may have been treated also.
PD4107-152
PD4104-1274
Ash Flat, AR