Author Topic: Prevost part needed.  (Read 1047 times)

Offline scanzel

  • Hero Member
  • *****
  • Posts: 861
Prevost part needed.
« on: August 22, 2018, 04:03:18 PM »
I am looking for the dashboard switch that controls the air and heater blower motors, it is a multi position switch that gives variable speeds to the blowers. Prevost does not have any in their system and it is made in France. I have 24 volts into the switch but neither blower motor will work in either air or heat mode. If anyone knows of a vehicle being parted out or even has one that I could borrow for further testing or knows of where i may find one let me know. Without the switch I cannot get air or heat to dashboard area. Thank you.
Steve Canzellarini
Myrtle Beach, SC
1989 Prevost XL

Offline robertglines1

  • steam nut
  • Hero Member
  • *****
  • Posts: 4557
Re: Prevost part needed.
« Reply #1 on: August 22, 2018, 05:37:45 PM »
behind dash right of steering wheel there are a pair of cube type relays. Check them for ground.  I tried a cole-hertse (sp) variable speed 24 volt switch= it fried/smoked out. I have already passed my extra switch on to needy busnut.  Base must have good ground
Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana

Online luvrbus

  • Hero Member
  • *****
  • Posts: 26067
Re: Prevost part needed.
« Reply #2 on: August 22, 2018, 05:42:18 PM »
On Face/Book they are scraping out Prevost daily in the Nashville area,the Prevost guys have a page ask and you shall receive there   
Life is short drink the good wine first

Offline scanzel

  • Hero Member
  • *****
  • Posts: 861
Re: Prevost part needed.
« Reply #3 on: August 27, 2018, 05:12:53 PM »
I don't do Face Book any other way to contact these Prevost guys in Nashville ?
Steve Canzellarini
Myrtle Beach, SC
1989 Prevost XL

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal